Foshan Thumbs-Up stainless steel co.,Ltd is a set of stainless steel sheet and stainless steel coil as one of the supporting manufacturers.

how to build a coil How to Build a Wind Turbine - Building a Homemade DIY Wind Power Turbine

by:Thumbs-Up     2019-08-12
For families and small time makers who want to explore the potential of wind power generation in their own field, learning how to build wind turbines is really a rewarding task.For these materials, all you need is pencil and paper, glue gun, plywood, voltmeter, enamel magnet wire, screwdriver, square pin, tool knife, 5mm LED, tape measure, washer, electric tape, eye nail, white glue, square nail braces, compass and cardboard.These materials are easy to find.In fact, you can find these materials and tools in the comfort of your own home.The first step in how to build a wind turbine is to make a homemade propeller blade.Cut two halves off the paper and stick together.Corrugated Board.Stick the paper on it and cut out the shape.You need a piece of plywood to make the base.You have to use a 6-The Cm radius is then marked with an angle line of 90 degrees.Next, drill the wood screws in the center of the plywood.From there, in order to create the turbine stand, about 8 cm of the two directions are measured.To make the frame, attach the vertical turbine bracket at the 8 cm mark.Make foot base for both.Place it in the middle of the frame with the eye screw, then slide the pin over the eye screw.The next step in how to build a wind turbine is to create a coil.Just fix the cardboard around yourself with tape.Then, wrap around it about 200 wires, about 4 times.After that, remove the wire packaging from the cardboard and fix it down using electric tape.With a voltmeter, you can test the current at the end of the coil.Then, put the coil on the base.Use the LED as the start and end area to connect the coil to the adjacent coil in the series.Stick the coil to the base.For the final steps on how to build a wind turbine, this process will include the magnet and the tower itself.For magnets, cut a disc shape from the cardboard measuring 6 cm.In the center of the cardboard, make a hole and then glue the gasket to the end point.You have to stick the magnet to these washers.For the tower, cut a water bottle in half and then remove them before sticking the top and bottom together.Connect them to the disc and make sure the end is off.Make another hole at the end point and put the round pin inside.Pins must be continuously inserted into the holes of the magnetic disc.The magnet must face the coil and there should be a sharp point at the bottom of the pin.Pins must be continuously inserted into the holes of the magnetic disc.The magnet must face the coil and there should be a sharp point at the bottom of the pin.
Custom message
Chat Online 编辑模式下无法使用
Chat Online inputting...